Tennis Ball 3D Deco Light by 3D Light FX
Tennis Ball 3D Deco Light by 3D Light FX Product Description
3D Tennis Ball Lights with crack sticker, making it appear like the object has broken through the wall.
- Realistic Size
- LED Lights
- Size of each light: 7.5 cm x 7.5cm x 6cm
How to install your 3D Crack Sticker
1. Unfold sticker and flatten creases.
2. Place sticker at desired location, place tape (painter’s tape or similar) at the edge of the top of the sticker and mark arrows on tape and sticker for placement reference.
3. Carefully remove the back of the sticker.
4. Align arrows and carefully stick the top (top 1-2 inches) of the sticker to wall, make sure you hold the bottom portion away from wall.
5. Use a credit card or dull flat surface to slowly adhere the sticker, pressing against the paper backing, removing any air bubbles that may arise, remember to keep the bottom part of the sticker off the wall as you work your way down, out and towards the edges until the end.
6. Very slowly peel off the paper from the wall, making sure that the (fine edges) are stuck to wall. If any of the sticker peels up with the paper, simply put back against wall and press firmly with credit card until sticker adheres to wall.
7. Drill a hole in the spaces marked X and inset the wall plug, provided. Insert the screws provided to approximately ¾ of the way and place light onto screws.
How to remove your 3D Crack sticker without damaging your wall
Warning! – Sticker removal should be done by an adult only.
1 – Please remove the screws from the wall prior to removing the crack sticker.
2 – Using a standard hair dyer set the heat to the highest setting.
3 – Applying heat to the sticker should be done evenly… holding the dryer 1-2 inches from the wall.
4 – Make sure to heat the entire surface before attempting to remove the sticker
5 – Once you have heated the entire sticker, start to remove the sticker from the top slowly pulling it off the wall in a downward motion.
6 – Position dryer above the sticker as you pull it off to help release the adhesive.
7 – For best results please do not rush this process. Take your time and remove the sticker slowly.
8 – Use warm water with soap to remove some of the left over adhesive.
NOTE – This process will vary depending on the climate in your area and how long the sticker has been on your wall.
Important Safety Instructions
Please read all instructions first before applying sticker and mounting 3D Deco/Night Lights. You can apply your 3D Crack ticker to any smooth ﬂat surface but make sure it is clean of dirt or grit and completely dry. Newly painted walls need at least 2 weeks before applying sticker.
The 3D Deco Lights are NOT toys.
DO NOT mount 3D Deco Lights in reach of children.
Important Safety Instructions
• For indoor use only.
• Do not use in or near water.
• Mount only on a surface that is mechanically sound.
• Do not mount near gas or electric heaters, fireplaces, candles, or other sources of heat.
Important Safety Instructions when using Batteries with this product.
• Placing the batteries for the first time and replacing the batteries should be done by adults only.
• Use AA or AAA batteries only.
• Turn Light off during the day to conserve battery life.
• Dispose of batteries safely.
Reviews of Tennis Ball 3D Deco Light by 3D Light FX
Unfortunately, We don't currently have any reviews for this product.
Why not be the first to write about Tennis Ball 3D Deco Light by 3D Light FX?
Why buy from shop4world.com?
We've been trading online for several years.
All orders are insured and delivered to your address with the best of care.
We're working with the best and most secure payment gateways.
Get rewarded with Player Points! Saving you even more money!