Bring your room to life with Hasbro’s Transformers Optimus Prime 3D FX Night Light, a fun, energy efficient & wireless wall mounted light that literally looks like Optimus Prime is bursting through your wall! This licensed and innovative 3D light is perfect for kids, teens and even adults!
- Includes Optimus Prime head light and crack decal sicker
- Cordless night light - no wires!
- 2 On settings: eyes on & eyes and backlight on
- Battery Operated - Requires 3 x AA batteries (not included)
- Runs on energy efficient LEDS (Never change the bulbs)
- Never gets too hot to touch
- All supports included for hanging
- Looks awesome on or off
- Realistic looking wall light
- Fun for any age!
- Simple installation
Convenient & Practical
- Approx. Size: 32.5cm (H) x 21cm (W) x 10.5cm (D).
- Provides a comforting light for infants and children to fall asleep.
- Provides enough light for parents to see the infants without turning on additional lighting.
- Children can move about the room and take themselves in and out of their beds without turning on additional lighting.
- Can be placed close to the cot, bed or anywhere in the room (not restricted to outlet locations).
How to install your 3D Crack Sticker
- Unfold sticker and flatten creases.
- Place sticker at desired location, place tape (painter’s tape or similar) at the edge of the top of the sticker and mark arrows on tape and sticker for placement reference.
- Carefully remove the back of the sticker.
- Align arrows and carefully stick the top (top 1-2 inches) of the sticker to wall, make sure you hold the bottom portion away from wall.
- Use a credit card or dull flat surface to slowly adhere the sticker, pressing against the paper backing, removing any air bubbles that may arise, remember to keep the bottom part of the sticker off the wall as you work your way down, out and towards the edges until the end.
- Very slowly peel off the paper from the wall, making sure that the (fine edges) are stuck to wall. If any of the sticker peels up with the paper, simply put back against wall and press firmly with credit card until sticker adheres to wall.
- Drill a hole in the spaces marked X and inset the wall plug, provided. Insert the screws provided to approximately ¾ of the way and place light onto screws.
Important Safety Instructions
- Make sure the surface you are mounting the light to is clean of dirt or grit and completely dry.
- Newly painted walls will need at least two weeks before applying the sticker
- For indoor use only
- Do not mount/use near water, gas & electric heaters, fireplaces, candles, or any other sources of heat.
- Keep out of reach of children, the 3D deco lights are not toys.
The lights require 3-AA batteries which are not included. Please make sure the batteries are installed & replaced by adults.
For best results, turn light off during the day and use new, high quality batteries. New Batteries will last for 2 - 3 weeks, depending on usage.